Instant pot beef tips and noodles recipe (2024)

FAQs

Why is my stew meat tough in Instant Pot? ›

Skip the stew meat and start with boneless beef chuck.

Stew meat is often cut into irregularly shaped pieces, which won't cook evenly and the pieces can be smaller than you want when making stew in your Instant Pot. Additionally stew meat tends to have more tough gristle, which will never get tender.

For example, cook a 2-pound pot roast at high pressure for 40 minutes and a 3-pound pot roast for 60 minutes. Frozen beef: I highly recommend thawing your beef for this recipe, since you cannot sear the frozen beef. If you must use frozen beef, assume 30 minutes per pound.

Put meat on the bottom

It's not just pasta that should be on top – order matters with the instant pot. In general, it works out best if you put meat on the bottom. Here's why – anything that has sugars in it can burn if cooked too long.

Unfortunately, once you overcook a piece of meat in the pressure cooker, there's no going back. You'll be left with a pile of dry, crunchy, tasteless fibers and no amount of additional pressure cooking is going to put that moisture back into the meat.

Chuck meat is your best bet for beef stew, but it's also a pretty tough cut so it needs time to break down and become tender. Rush the cooking process and the beef will be tough and chewy. Follow this tip: For really tender meat, cook the stew low and slow, for approximately two hours.

No, just enough to keep moist while cooking - add more if you need to but usually the meat releases liquid as it cooks and it is not necessary to add more liquid.

Place your trivet or steaming basket into the inner pot. Add 1 cup of water. Place your ground meat on the trivet/in the steamer basket. Cook for 6 minutes at high pressure.

You can still pressure cook leaner pieces – like eye of round and top sirloin – but these work best if they've been stuffed, shredded or rolled (with other ingredients). Best cuts of beef to use: Chuck steak, Round Roast, Shoulder, Pot roast, Ribs, Brisket, Oxtail.

Brown it

Pressure cooked food doesn't brown so it's worth doing this at the start of cooking before adding liquid and putting the lid on. Meat looks and tastes more appetising with a little browning. Onions, garlic and spices also benefit in the flavour stakes from pre-cooking.

Use the Right Ingredients: Tough cuts of meat, such as beef chuck or pork shoulder, benefit the most from searing before pressure cooking. However, you can also sear vegetables and seafood to enhance their flavor.

Should I brown meat before putting in pressure cooker? ›

DO brown or broil it. Either give your meat a quick all-around sauté before starting a braise or tumble pressure steamed or boiled meat on a heat-proof platter and slide it under the broiler for a few minutes to add a beautiful I-'ve-been-cooking-in-a-blasting-hot-oven-for-hours finish. DON'T drown it.

This can be achieved by simmering the stew on low heat for a long period, either on the stovetop, in a slow cooker, or in the oven. The low and slow cooking technique allows the collagen in the meat to break down, resulting in tender and juicy meat.

Simmer in liquid. Just like for burnt meat, if your meat gets tough and dry then you can simmer it in a little bit of broth for a couple minutes. Don't allow it to overcook again but just allow the liquid to penetrate the meat.

Cooking meat does not make it tough, it gets more tender. Meat does get dry at higher temperatures, time does not matter that much. The higher the temperature the more moisture is squeezed out of the meat making it more dry, I guess that it what you describe as tough.